Flooring from hardwood boards

Hardwood plank boards on wooden sleepers antiseptirovannym thickness of 25-40 mm (thickness depends on the type of intercommunication floor). Laghi recommended to lay the premises along parallel rows, strictly on a level with the distance between axles 400 mm. Shield size 800x800 mm should be based on three logs, one of which is under the middle of the shield, and two others - at its edges. Boards with nails attached to a long lag of 60-70 mm. Logs are placed in soundproof backing or pads. Plank boards are somewhat easier than hardwood boards. Laying technique is as follows. First of all, define the place for the Lighthouse series, for which the floor space pull two cords which intersect at right angles. One of them runs along the long side of the room at a distance of 810 mm from the wall (800 mm length of the shield plus 10-15 mm gap between the shield and the wall), the other - at the same distance from the short wall. According to this column, packed by the letter F, placed two series of panels of Lighthouse, the first - in the corner farthest from the entrance. Checking the correctness of placing the shield on the cord, it nailed to each lag. If you use boards with the grooves, then put in their bonding with three spines and they skewer the following boards (Fig. 35). At the edge of the panels, facing the wall, you can drive nails from the top: cap them in the future will be covered with skirting no less than 10-12 mm. If the panels are manufactured with grooves and ridges, the edges with ridges turning to the walls. Hammer nails obliquely to the bottom groove cheek and utaplivayut their hats doboynikom. Each shield hammer tightly joined to the previous one, so that their edges tightly converged, and the crest of the second board is fully seated in the groove of the first. In order not to spoil the edges with a hammer, you should put a pad under it. Each panel must fasten with nails to lag. If the shields do not fit into the room, then cut off by sending to the walls or partitions and nail from the front, again to cap and then shut down baseboards to 10-12 mm. After laying parquet varnish or rubbing compound.