Angular vrubka round logs "in the bowl»

Svyatoslav Otychko Corner vrubka can firmly link the two walls of a house into a single design. To its choice of independent and exterior of the house. When cutting "in a bowl" in the log is only one groove on its underside. Tools and materials: 1. Level 2. A saw, hatchet, chisel 3. Tow 4. Material for covering the finished corner of the house (sheets of canvas or metal) Process: 1. Install new timber over the previous approximately at the point of final installation. It should be based on the cap upside down. 2. Take the level and on a side draw a vertical line cut logs. By that point we will later check that the wall is vertical. 3. Set the compass at the carpentry is the distance between the lugs to fit the size of the groove design value. 4. Preserving the distance between the tips, proverchivaem as a groove, and the contour of gouging the sample from both sides of the logs. 5. Logs are turning up and attaches to gouging. 6. Gouge doing pothole along the groove of the castle. Chainsaw in the log Scrollsaw as a large piece for the slot of the castle. At the same time remember that the grooves can not pass line. 7. Move the tip of a chainsaw in a lateral direction from the groove vypilivaya remaining material. No need to go too to the edge, because when working with a chisel detached surface of the timber. 8. Attach to the bottom of the excavation slightly curved shape - this space is useful for the tow. 9. After a corner of the castle hollow longitudinal groove logs. 10. Set the timber in place and check the angular vrubki and grooves. Where necessary, make further development and to remove individual hooks. Small defects can be corrected fret, more significant - gouging. 11. The log is ready for installation.