Finish flooring

Gouging flooring is needed when the parquet nastlan carelessly and individual plates strongly favor or when flooring strongly detest. Planing operates planes and jack-plane with a well-Edged and directed knives. Planed wood in the direction of the fibers. Parquet, rubbed with a wet rag, planed easier, but less pure than the dry. Planing carry on his knees. To lower your knees feel the hardness of the parquet, under which enclose something soft, and for large volumes of the master-parquet wearing specially sewn felt kneepads. Sanding parquet perform in order to clean up the wood surface after planing, since it is often a lot of lint. Tsiklyuyut on wet and dry wood. The wet tsiklevat easier, but after drying on the surface may remain nap. To remove it, it is necessary to re-tsiklevat well-Edged and directed cycle. Sanding of dry wood a lot harder, but surface is cleaner, lint-free cloth. Sharpen and direct cycle in this case there is more. Procedure for sanding next. Sweep floors, remove some contamination, wipe a small portion of the floor with a damp cloth or foam. (Very wet the flooring can not be, since it dries, strips could warp.) Series takes two hands, puts a parquet floor, and with the push of moving it over, remove the chip (Fig. 44). Chipping periodically sweep to the side so it does not interfere with work. Cycle are along the strip in the direction of fibers, and not vice versa, so there was no scoring. Sanding parquet only intact, but do not align depression and sag. To align the floor, separate places tsiklyuyut 2-3 times or more, and therefore easier to complete ostrogat. After sanding parquet wood from sawmills, such as oak, beech, is a brilliant and polished or varnished with mastic has a good gloss. Polishing paste and varnish coating protects floors from dirt and moisture quickly, give them shine, highlighting the texture of wood. Caring for these floors is more simple and less laborious than rough. Waxes are using different flooring mastics: some pre-diluted with water, others put on the floor with a thin layer and rubbed by hand or polisher. For each of mastic, commercially available, is attached instructions (printed on the packaging or on a separate sheet) according to which it is necessary to prepare and apply. Some artists recommend rub-parquet oak flooring mastics water, and beech and other species - anhydrous. Water putty is diluted in a sturdy pot with hot water. From the floor remove dirt and dust and cause a thin layer of paste evenly with a brush or rag. Once dry the first layer of mastic, floor cover again. After drying mastic flooring rubbed hard hair brush or a polisher, which is much faster and easier, and the floor is a more brilliant. Mastic on the basis of turpentine breed is not necessary. Cause her twice with a thin layer with a cloth or stiff brush and a good grind, and after drying, the floor scrubbed. Varnish is more reliable. Luck is sold packed in sealed dishes, in which there is instruction on its use. Before the flooring varnish it well clear of all possible contaminants, mastics and dust. Lacquered floors to dry certain times specified in the instructions.