Laying parquet different pattern

Parquet plank squares, straight lines, and deployed, as well as straight lines, carpet (Fig. 43), with and without a frieze frieze. When laying the flooring straight square plates are arranged parallel to the walls of the room. With almost no need cut strips. When laying parquet expanded square plates have a 45 ° angle to the walls of the room. Blog square can be done without waste way, but you have to saw a lot of strips to fill the triangles, which remain in the ground of contiguity parquet flooring to the walls and frieze. A plan laying parquet in the form of squares, first spread a strip of bars and the width of the room. It is advisable to select strap long enough to figure lay on the ground with the least amount of waste. Of course, the wall, you can use strips of other sizes. When properly drafted terms of laying the ends of strips have to saw off only after the laying of one of the short sides of the room. Laying lighthouse series of squares pull cord across the room. On the stretched cord plank plank in mastic or a nail. Lighthouse series plank as evenly as possible. Perform parquet pattern unfolded square starting with a trial installation dry squares on the diagonal of the room. Trims pick such a size that can be put across the room is an integer squares. The first series start plank from the wall at a distance equal to half the diagonal of the square plus a 15-20 mm gap between the wall and flooring. This distance is set aside from the corners of the room. On the opposite long walls are the points to pull the cord. When laying the parquet pattern unfolded square with friezes pull cord is not between two opposing walls, and between the lines, which limit the frieze series. Perform parquet pattern is easy to direct, and therefore the plan does not require installation. Here, use long strips 350-400 and 35-40 mm wide. In order not to mow down the first row of flooring, it is necessary to pull the cord along the long axis of the room. Parquet strips can be used in any length, but always the same width. Run drawing "carpet" is simple: first pull on the cord, then laid strips along the long wall, and then - perpendicular to it.