Flooring of inlaid (mosaic) flooring

This flooring is a square board (or cover), recruited from bars of different lengths and thicknesses, glued on thick paper face. The back of the shield bonded to the substrate with a bituminous mastic. In addition, there are parquet, glued back (back) side on a solid elastic material, which then remains in the design and after laying the parquet. Carpets come in different sizes, so they should be selected in accordance with the size of the room, assuming that the room if possible fit a whole number of squares-carpet. Previously for each building must choose rugs by size, pattern, color and wood species. Good selection is such as integer carpets fit without any additives at one time or another room. Selected carpets recommended again to sort, so that one shade carpets were in the first row, the other - in the second, etc. plank flooring on a hard bottom, mostly on a concrete screed. Screed must be done very precisely, with deviations of no more than 1 mm. Validation is performed fugovannoy rack 2 m Flooring is made on a hardwood floor mastic. The back side of carpet should come into contact with cement and the screed not less than 80% of the area rug. At 100% by Mr. adjacency mat screed to provide the most reliable bonding. On the thickness of mastic also depends on the strength of gluing. Pre-before gluing parquet paste to be mixed thoroughly and check it out thickness (see Fig. 32). Inlaid parquet plank so (Fig. 36). Along two walls pull two cords, perpendicular to each other. Instead of cables along the walls can be strengthened by putting an edge on an angle of 90 ° to each other, two fugovannye rail thickness of 15-20 mm. Slats are glued to the bottom of the hot mastic or permanently affixed to the walls. Reiki - a reliable stop for the mosaic parquet carpet. After removing the rods provide the necessary clearance between the wall and carpet flooring, which further closes the skirting. Reiki should take such length that along them could lay carpet 06/08. The first rugs lay along the guide rails. First plank front rows on both sides, then - the second. The first carpet the second row is placed in the angle between the first two rugs, carpet and a second - between the first and second. Each subsequent carpet edges rests not in one, but two previously arranged, which provides a flat packing. Plank inlaid parquet comfortably together: one meat in and brings the material pours cold mastic and leveled it with a notched trowel, and the second puts the first mat in the corner, tight utaplivaya it in a layer of mastic. Others carpets consistently placed, tightly holding them to the ground before packed carpets pripressovyvaya lightly with a hammer. Mastic is spread with a notched trowel, allowing to obtain on the basis of a thin even layer of mastic equal thickness. Embossed the seams mastic immediately removed with a spatula, knife or other sharp instrument and wipe clean with dry cloth. To layer or traces of mastic were not visible, such places are best protsiklevat. To paste is not squeezed when laying carpet, they were first pressed to the edges of the previously packed carpets, and then dipped in paste. Within 3-5 days after the end of carpeting, ie, after curing mastic, with parquet, nastlannogo on the floor, remove the paper. Paper pre-moistened lightly with a cloth or brush dipped in water. Finally, trim flooring after installation of baseboards.